The XM1 doesn't have any smoothing or acceleration by default. The PixArt PMW3389 sensor has smoothing by default above ~1900 CPI in order to reduce jitter. When Ripple Control is enabled, it doesn't have any influence below 1900 CPI, but above this threshold, smoothing is applied and jitter reduced, at the cost of a few frames of added motion delay.
Articles in this section
- What is "Motion Jitter Filter" in the software?
- Where can I buy the OP1 8k Purple Frost?
- My mouse is frequently disconnecting.
- Does the gf range mean that the switches can be manually adjusted between listed force range of actuation?
- Can I change the switches?
- Can I configure my EndGame Gear mouse or keyboard for MacOS or Linux?
- General information: Motion Sync
- General information: Button Tensioning
- General information: Slamclick
- General information: Skates