The XM1/XM1r mice utilize a 5-pin JST PH 2.0mm connector with the following wire arrangement: 1. SHIELD 2. BLACK 3. WHITE 4. GREEN 5. RED Refer to the provided example image for further clarity. The OP1/OP1 RGB and OP1 8k utilize a 5-pin JST PH 1.5mm connector with the following wire arrangement: 1. SHIELD 2. BLACK 3. GREEN 4. WHITE 5. RED For the OP1 series, the GREEN and WHITE wires need to be swapped with regards to the image below. If you need guidance on how to swap these small cables, a helpful tutorial can be found at the following YouTube link: https://www.youtube.com/watch?v=STW3msLuZeE. This step-by-step guide will walk you through the process, ensuring successful cable replacement for your wired mouse. Please note that we do not recommend swapping the cable on the OP1 8k. Due to its high polling rate, changing the cable can lead to polling rate instability and other issues.
Articles in this section
- Does the gf range mean that the switches can be manually adjusted between listed force range of actuation?
- Is soldering required when swapping out the switches?
- Can I configure my EndGame Gear mouse or keyboard for MacOS or Linux?
- General information: Motion Sync
- General information: Button Tensioning
- General information: Slamclick
- General information: Skates
- General Information: Multiclick Filter
- General information: Lift-off Distance
- General information: JST